Please check drainage on back wall to be clear.
Please contact Nikan Golden Services.
There is too much water in ice maker tray holes therefore ice cubes get stuck together.
The fridge door does not close properly. It is possible that the seals or the door have problem.
It is possible the environment that the fridge is located in, is very warm and humid.
Maybe you had put hot food in the fridge.
Open and close the door, if the problem persists call Nikan Golden Service.
When you close the door you should not open it immediately because in time of closing vacuum is generated, it causes suction and pulls the door inside. In this situation door gets opened with difficulty.
Please be advised that in case of opening the door, seal and handle might get damaged.
You open and close the door too many times.
The temperature setting is high and should be set on lower degrees.
You had put too much food inside the fridge and it has blocked cold air circulation between shelves.
There is too much frost inside product. Please contact Nikan Golden Service.
This is caused after the long power cut off. In this case you should reset the unit. For resetting the unit, turn product off by using temperature setting volumes, turn to off position and wait few minutes then turn unit back on; problem usually resolves. In case the problem persists, please contact Nikan Golden Services.
This is normal. Standard distances from the Walls are 5 cm, from the Top 30 cm and from back is 10 cm. These distances should be considered.
It is possible that the product is set to off.
Check the socket and the plug.
In case that the plug is connected to the protector, transformer, extension cords or multiple plugs; please remove these items and connect the plug directly to socket.
In case that you did all of the above and the problem still persists, kindly contact Nikan Golden Services.
It’s normal because the compressor fan and condenser are below the product.